To install memory and font DIMMs

1. Turn the printer off.

   

2. Disconnect all power and interface cables.

   

3. Open the DIMM access door by gently prying it with a flat-bladed screwdriver. Remove the door by pulling the door toward the back of the printer.

   

4. Loosen the screws that hold the formatter door on the printer. Remove the formatter door.

   

5. Remove the DIMM from the antistatic package. Locate the alignment notches on the bottom edge of the DIMM.

   

6. Holding the DIMM by the edges, align the notches on the DIMM with the bars in the DIMM slot.

   

7. Firmly press the DIMM straight into the slot. Close the locks on each side of the DIMM until they snap into place.

   

   NOTE	If you have difficulty inserting the DIMM or closing the latches, make sure the notches on the bottom of the DIMM are aligned with the bars in the slot. If the DIMM still does not go in, make sure you are using the correct type of DIMM.

8. Align the formatter door in the tracks at the bottom of the slot, and turn the screw to attach the formatter board to the printer.

   

9. Replace the DIMM access door by inserting the tabs on the door into the slots on the printer. Swing the door shut.

   

10. Reconnect the power cable and USB/parallel cable.

    

11. Turn the printer on.

    

12. If you installed a memory DIMM, go to Enabling memory. If you installed a language font DIMM, go to Enabling the language font DIMM.