To install an HP Jetdirect print server card

1. Turn the printer off.

   

2. Disconnect all power and interface cables.

   

3. Locate an empty EIO slot. Loosen and remove the two retaining screws holding the cover for the EIO slot onto the printer, and then remove the cover. You will not need these screws and cover again.

   

4. Firmly insert the HP Jetdirect print server card into the EIO slot. Insert and tighten the retaining screws that came with the print server card.

   

5. Connect the network cable.

   

6. Reconnect the power cable, and turn the printer on.

   

7. Print a configuration page (see Configuration page). In addition to a printer configuration page and a Supplies Status page, an HP Jetdirect configuration page that contains network configuration and status information should also print.

   If it does not print, uninstall and reinstall the print server card to ensure that it is completely seated in the slot.

8. Perform one of these steps:

   Choose the correct port. See the computer or operating system documentation for instructions.

   Reinstall the software, choosing the network installation this time.