To replace the pickup roller

Maintenance
   

To replace the pickup roller

NOTE

The printer should still be turned off.

  1. Remove Tray 2 and place it on a flat surface.

    HP 3550 3700 t2 remove To replace the pickup roller

  2. Use one finger to push on the blue side of the pickup roller until the peg comes out of the right hole.

    HP 3550 3700 instl pickup left To replace the pickup roller

  3. Pull down gently on the pickup roller to remove the left peg of the pickup roller from the printer.

    HP 3550 3700 instl pickup down To replace the pickup roller

  4. Remove the new pickup roller from the bag.

    NOTE

    For information on how to properly dispose of the used pickup roller, go to http://www.hp.com/recycle.

    HP 3550 3700 instl pickup bag To replace the pickup roller

  5. Hold the blue side of the pickup roller, and insert the left peg into the round hole in the printer.

    HP 3550 3700 instl pickup replace To replace the pickup roller

  6. Push in on the pickup roller while lifting up on the right side of the pickup roller, so the pin goes into the hole and clicks into place.

    HP 3550 3700 instl pickup up To replace the pickup roller

  7. Rotate the blue side of the pickup roller until it clicks into place.

    HP 3550 3700 instl pickup rotate To replace the pickup roller

  8. Replace Tray 2.

    HP 3550 3700 t2 replace To replace the pickup roller

  9. Turn the printer on. After a short time, the printer control panel might display the message NEW FUSER KIT.

  10. If the message NEW FUSER KIT appears, go to step 11. If the message does not appear, you must reset the fuser count. See To reset the fuser count.

  11. On the printer control panel, press HP 3550 3700 arrow down To replace the pickup roller to highlight YES, and then press HP 3550 3700 checkmark To replace the pickup roller to select it. The fuser count is reset and the printer is ready to use.

NOTE

If you want to continue printing past the end-of-life message, the fuser kit count must be reset using the printer control panel. Please note that the end-of-life message is provided as a customer service, and printing past it is likely to result in print quality degradation in the near future. Once the fuser kit count has been reset after an end-of-life message, feedback on the kit’s remaining life will be incorrect until the kit is replaced and the count is reset again.

HP 3550 3700 To replace the pickup roller