To replace the fuser

1. Turn the printer off.

   

2. Open the lower rear door (rear output bin).

   

   WARNING!	The fuser will be hot. Wait 10 minutes before proceeding.

3. Slide out the lower rear door (rear output bin) tray extender.

   

4. Lift and pull the lower rear door (rear output bin) while using your finger to press the tab with ridges on the left side of the door. Remove the lower rear door (rear output bin).

   

5. Place your thumbs on the blue ridges (near the warning label) and, using fingers, pull up on the blue latches.

   

6. Pull the fuser out of the printer.

   NOTE	For information on how to properly dispose of the used fuser, go to http://www.hp.com/recycle.

   

7. Remove the new fuser from the bag.

   

8. Hold the fuser with your thumbs on the blue ridges and fingers on the blue latches. Push both sides of the fuser into the printer.

   

9. Press the black ridges on the front of the fuser until the fuser clicks into place.

   

10. Rotate the green levers to the up position.

    

11. To reattach the lower rear door (rear output bin), hold the door at a 45º angle, and fit the peg into the round hole on the right side.

    

12. Press the ridges on the tab on the left side of the door, and fit the peg into the round hole.

    

13. Close the lower rear door (rear output bin).