Loading paper into Tray 3

1. Pull the tray out of the printer and remove any paper.

   

2. Raise the output bin extension.

   

3. Adjust the length guides. For letter-size paper, raise the blue rear stop. For A4-size paper, lower the blue rear stop.

   

4. Adjust the width guides. For letter-size paper, press the center of the side width guides outward as far as possible. For A4-size paper, press the blue ridges, on the outside of the side width guides, inward as far as possible.

   

5. Load the paper into the tray. If this is special paper, such as letterhead, load it with the side to be printed down and the top edge toward the front of the tray.

   NOTE	If you are duplex printing, see 2-sided (duplex) printing for loading instructions.

   

6. Make sure the stack of paper is flat in the tray at all four corners, and keep it below the height tabs.

   

7. Slide the tray back into the printer.