Configuring TCP/IP parameters using BOOTP or DHCP

I/O configuration
   

Configuring TCP/IP parameters using BOOTP or DHCP

  1. Press Menu to enter the MENUS.

  2. Press HP 3550 3700 arrow down Configuring TCP/IP parameters using BOOTP or DHCP to highlight Configure Device.

  3. Press HP 3550 3700 checkmark Configuring TCP/IP parameters using BOOTP or DHCP to select Configure Device.

  4. Press HP 3550 3700 arrow down Configuring TCP/IP parameters using BOOTP or DHCP to highlight I/O.

  5. Press HP 3550 3700 checkmark Configuring TCP/IP parameters using BOOTP or DHCP to select I/O.

  6. Press HP 3550 3700 arrow down Configuring TCP/IP parameters using BOOTP or DHCP to highlight EIO 1.

  7. Press HP 3550 3700 checkmark Configuring TCP/IP parameters using BOOTP or DHCP to select EIO 1.

  8. Press HP 3550 3700 arrow down Configuring TCP/IP parameters using BOOTP or DHCP to highlight TCP/IP.

  9. Press HP 3550 3700 checkmark Configuring TCP/IP parameters using BOOTP or DHCP to select TCP/IP.

  10. Press HP 3550 3700 checkmark Configuring TCP/IP parameters using BOOTP or DHCP to select CONFIG METHOD.

  11. Press HP 3550 3700 arrow down Configuring TCP/IP parameters using BOOTP or DHCP to highlight BOOTP or DHCP.

  12. Press HP 3550 3700 checkmark Configuring TCP/IP parameters using BOOTP or DHCP to save the setting.

  13. Press Menu to return to the Ready state.

HP 3550 3700 Configuring TCP/IP parameters using BOOTP or DHCP