Configuring trays

Printing tasks
   

Configuring trays


The HP Color LaserJet 3550 and 3700 series printer allows you to configure trays by type and size. You can load different paper in the printer trays and then request paper by type or size in the application or the printer driver.

NOTE

If you have used previous HP Color LaserJet printers, you might be accustomed to configuring Tray 1 to first mode or cassette mode. To mimic the settings for first mode, configure Tray 1 for ANY SIZE and ANY TYPE. The printer will pull paper from Tray 1 first (if paper is loaded in that tray) when the print job does not specify another tray. This setting is recommended if you use different types or sizes of paper in Tray 1. To mimic the settings from cassette mode, set either the size or type for Tray 1 to a setting other than ANY SIZE or ANY TYPE. This setting is recommended if you are using the same size and type of paper in Tray 1.

NOTE

If you use 2-sided printing, be sure that the paper loaded meets the specifications for duplex printing. (See Supported paper weights and sizes.)

The instructions below are for configuring the trays at the printer control panel. You can also configure the trays from your computer by accessing the embedded Web server. See Using the embedded Web server (HP Color LaserJet 3700 series printer only).

This section provides information about the following topics:

HP 3550 3700 Configuring trays